PrincipIoT FPV flight controller assembled in USA

I’m happy to announce the release of our new flight controller. It’s designed, assembled, and tested in the USA (proudly made in Bothell, WA).

We’ve been working hard for the last few months on developing an FPV flight controller to address the shortage of low cost, domestically produced components for sUAS. In a recent market survey we conducted, less than 5% of the FPV flight controllers available from major vendors are made in the USA or NDAA compliant.

Features:
STMicroelectronics F7 processor
TDK InvenSense ICM-42688-P IMU
Infineon Technologies DPS310 barometer

Standard connectors for ESC, Receiver, GPS, Camera, and VTX. All conforming to the Betaflight Connector Standard.

Three onboard power rails:
10V @ 2A for VTX
5V @ 2A for GPS, RX, camera, servos
3.3V @ 600mA for sensors

Fully compatible with Betaflight 4.5. INAV support coming soon.
Fits in a standard 30.5mm mounting pattern, only 7g and 38mm square.
Runs on 3-6S input power, with onboard voltage sensing
NDAA compliant version in development

More information: https://lnkd.in/gF2FZ8Ew

Units are available now for preorder, shipping at the end of Q3/early Q4. Reach out by DM or email (lukas@principiot.com) for more information, pricing, or to place a preorder.